Closed ChingPangggg closed 5 years ago
@monroews And is this what we should order? https://www.mcmaster.com/9162k476
COnsider meeting with Paul Charles to see if he would have a recommendation for an easier way to fabricate the rod. We previously purchased a threaded rod and then cut it down. The union looks good. You can probably get a threaded Tee and short pipe nipples to connect between T and check valves. You will also need nipples to connect union to check valves.
Also, since we now want the effluent to be 1" pipe size, we will need to fabricate a new air chamber, and then use an elbow to connect the air chamber with the check valve. Is this correct?
Draw a sketch and that will make it clear what pieces you need.
Tapping hole for pressure sensor on T-joint: Drill bit: 7/16 Tap: 1/4in- 18 (or 16?)
@monroews We are not sure about what to buy for fabrication of a new ram pump.