Figure out issues for the RGB Sensor (continuing)
Test and established sensors with submersible casing (3D Printed)
Figure out testing apparatus (find a "sludge blanket" to test with)(could ask UASB)
Finding an extendable pole (continuing)
To-Dos:
Week of Nov. 19 -
Test waterproof of submersible - Done
Test change if intensity in the 3D printed casing - Done
Install semi-permanent sensors
Start experiments in order to detect sludge blanket
There is a notable difference when the sensor is put into the red dye water compare to clear dye
Goals:
Figure out issues for the RGB Sensor (continuing) Test and established sensors with submersible casing (3D Printed) Figure out testing apparatus (find a "sludge blanket" to test with)(could ask UASB) Finding an extendable pole (continuing) To-Dos:
Week of Nov. 19 -
Test waterproof of submersible - Done Test change if intensity in the 3D printed casing - Done Install semi-permanent sensors Start experiments in order to detect sludge blanket
Troubleshoot RGB Sensor (check color vs colored light) Fix soldering for TEMT sensor - fixed
Used 510 ohm resistor for LED in setup Saul has the dimensions of the floc hopper