Waveshare connector doesn't fit the servo wire

AlexanderKoch-Koch / low_cost_robot

MIT License

2.95k stars 244 forks source link

Open MichaelrMentele opened 2 months ago

MichaelrMentele commented 2 months ago

The connectors do not fit together. If this is expected it would be good to extend the instruction to trim the connector.

MichaelrMentele commented 2 months ago

Highly likely I am confused -- unfamiliar with all this. Going off of the dynamixel quickstart example. https://www.youtube.com/watch?v=JRRZW_l1V-U

Screenshots for each step would be great.

MichaelrMentele commented 1 month ago

I ended up clipping off the outter edge but can't seem to keep motors powered.

moaazsidat commented 1 month ago

@MichaelrMentele you'll need male-female jumper wires to connect these

meetsitaram commented 2 weeks ago

I used extra wires to connect it this way. waveshare-to-servo-wires