search

Alexanderallenbrown / MotionBase

An open-source motion platform for driving simulation
16 stars 6 forks source link

Work on inverter today? #16

Closed wangzeyi closed 8 years ago

wangzeyi commented 8 years ago

Hello Professor @Alexanderallenbrown :

Shall we work on the inverter today?

@macjones743 @dallisg711

Alexanderallenbrown commented 8 years ago

Hey Andy

You can work on it if you wish. Please send me an email when you are ready to plug it in for the first time so I can drop by and check the wiring.

Sent from my iPhone

On Mar 19, 2016, at 11:21 AM, wangzeyi notifications@github.com wrote:

Hello Professor @Alexanderallenbrown :

Shall we work on the inverter today?

@macjones743 @dallisg711

— You are receiving this because you were mentioned. Reply to this email directly or view it on GitHub

wangzeyi commented 8 years ago

Hello professor @Alexanderallenbrown:

There are three wires from the source, and the inverter only takes two wires, how do we do that?

Alexanderallenbrown commented 8 years ago

There are two screws on the bottom of the case that are for the green ground wire. This is true of both the motor and the source cable.

Sent from my iPhone

On Mar 19, 2016, at 11:41 AM, wangzeyi notifications@github.com wrote:

Hello professor @Alexanderallenbrown:

There are three wires from the source, and the inverter only takes two wires, how do we do that?

— You are receiving this because you were mentioned. Reply to this email directly or view it on GitHub

wangzeyi commented 8 years ago

@macjones743 the code is fixed! I made a terrible mistake.

Want to connect the arduino to the inverter to test the code, and work on position control?

wangzeyi commented 8 years ago

Hello professor @Alexanderallenbrown

I was testing our transistors, and found that one of them was not working! @macjones743 Where can we get a good tramsistor?