search

AllYarnsAreBeautiful / ayab-desktop

The AYAB Software
http://ayab-knitting.com
GNU General Public License v3.0
62 stars 31 forks source link

Needle's сhaos with KH-270 #666

Open Ilushock opened 6 months ago

Ilushock commented 6 months ago

When working with the KH-270, the needles do not extend according to the pattern. And with one carriage pass, the program jumps several rows. https://youtube.com/shorts/DSwEv1ZO8jg?feature=share

X-sam commented 5 months ago

Which version of AYAB Desktop are you running? Which hardware do you have?

Ilushock commented 5 months ago

We tried desktop versions from 0.99rc1 to 0.99-rc6. Hardware version is 1.4TH.

clholgat commented 5 months ago

Did you start with both magnets to the left of the turn mark? If only one of them is then it will be misaligned.

Ilushock commented 5 months ago

We've tried different things, the results were also different but incorrect. Please watch the video from the link in the first post.

Adrienne200 commented 5 months ago

The image you're using is 96 stitches wide, right? But you're only using about 30 needles. Did you adjust the Start-needle and Stop-needle to match the actual needles in use? I think you'd need to take the carriage all the way out to left-48 and Right-48 to make it work the way you have it set up. Though having said, I tried what I think you're doing, and got different behavior. I also found a different issue, see #667, but not the multiple lines that you are seeing. Can you confirm that you reflashed the firmware since you installed rc6? Do you have the latest Arduino drivers? (I'm using the interface which uses different drivers, should behave the same as the shield. And I'm on a Mac, I need to try Windows.)