Closed EkiciLP closed 6 months ago
A few things here. Recycled filament is never going to be as consistent as new filament, so keep that in mind. Additionally, this photo is not well-focused and is very compressed. It is difficult for anyone to give you advice when it is hard to see what is going on. You may want to cover a wider range when starting your testing such as from .01 to .08 with .005 increments as the guide indicates. Finally, I don't think this is a proper place for troubleshooting your printer; rather, it should be used for issues with the guide itself. I would head to either the klipper or the prusa3d discord server (other-fdm section) and ask for help there.
Hey,
I have an Anycubic Vyper with direct extruder mod and wanted to calibrate it with your guide, which is, may I say, a life saver for people like me so thank you. Im using Prusament recycled But I ran into an issue when calibrate PA using Klipper. For some reason the corners are rounded on all lines. I have attached a picture of my Test pattern.
What can I do to fix that?