search

AndrewEllis93 / Print-Tuning-Guide

1.97k stars 260 forks source link

Bulging on seams #56

Open AMFkuna opened 1 year ago

AMFkuna commented 1 year ago

Hi, what can cause this bulging on seams? I use Ellis standart 45deg 15mm/s profile

thanks for hints

IMG_4364

ipatch commented 1 year ago

i've notice similar artifacts while printing at higher speeds. and asked a question on the klipper subreddit below,

https://www.reddit.com/r/klippers/comments/10pj1o5/rounder_corners_at_high_speed_printing_test_box/

FWR, when looking through my printer.cfg i did not have a square corner velocity setting,

https://www.klipper3d.org/Config_Reference.html#printer

i've since added it to my printer.cfg and am now printing a new test box to see if the results improve.