I have followed the guide for useful macros, I set up the BTT smart sensor and used the config and macros suggested. I now have two oddities that I can't figure out (still learning here) 1st. In my start config I added SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=1 and now after my purge lines the printer goes into a pause on its own. I click resume and it continues. I don't see where I have this setup wrong. 2nd and this may be related to the 1st my timelapse has stopped working after setting up the smart sensor configs.
I have followed the guide for useful macros, I set up the BTT smart sensor and used the config and macros suggested. I now have two oddities that I can't figure out (still learning here) 1st. In my start config I added SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=1 and now after my purge lines the printer goes into a pause on its own. I click resume and it continues. I don't see where I have this setup wrong. 2nd and this may be related to the 1st my timelapse has stopped working after setting up the smart sensor configs.
Fixed