Current software to use

AngelLM / Thor

DIY 3D Printable Robotic Arm

Creative Commons Attribution Share Alike 4.0 International

953 stars 223 forks source link

Closed LoLo2207 closed 3 years ago

LoLo2207 commented 5 years ago

Hi, I have an Ultratronics Pro board but I don't know what firmware to use. Is there any firmware available for this board?

If there isn't, what board can I use to easily wire and control the arm besides the custom PCB?

DavidVives commented 5 years ago

Dear LoLo2207, did you find any board and firmware that works? Many thanks and best regards

AngelLM commented 3 years ago

As far as I know, currently there is no other option than Arduino Mega + ThorControlPCB with the GRBL Thor version