I am switching from VDSL to bonded VDSL where instead of the modem features the connection will be done over ethernet cable.
My modem is:
Product Name DGA ( DGA4132 )
Software Version AGTHP_2.0.0
GUI: 9.6.65
In order to do that I need to change the parameters from the GUI. Unfortunately I am not able to see any similar option. In the past two days I was reading a lot of posts but none of them was clear how I can make a modification to achieve this required from T-mobile:
General parameters for VDSL when connecting a modem via VDSL bonding bridge (Terminator)
This is a connection where the Ethernet cable (RJ45) from the Cetin Terminator leads to the WAN port of the xDSL modem.
Parameter Value
WAN service type PPPoE
Type Ethernet
MTU 1492
VLAN allow
802.1P Priority 0
802.1Q VLAN ID 848
PPP Username adsl
PPP Password adsl__
Appreciate any suggestions how this setting can be done.
FrancYescO
commented
3 years ago 
Hi all,
I am switching from VDSL to bonded VDSL where instead of the modem features the connection will be done over ethernet cable.
My modem is:
Product Name DGA ( DGA4132 ) Software Version AGTHP_2.0.0 GUI: 9.6.65
In order to do that I need to change the parameters from the GUI. Unfortunately I am not able to see any similar option. In the past two days I was reading a lot of posts but none of them was clear how I can make a modification to achieve this required from T-mobile:
General parameters for VDSL when connecting a modem via VDSL bonding bridge (Terminator) This is a connection where the Ethernet cable (RJ45) from the Cetin Terminator leads to the WAN port of the xDSL modem.
Parameter Value WAN service type PPPoE Type Ethernet MTU 1492 VLAN allow 802.1P Priority 0 802.1Q VLAN ID 848 PPP Username adsl PPP Password adsl__
Appreciate any suggestions how this setting can be done.
Thank you in advance DelDos