search

Aplyard / Oled-Clicker

Clicker Counter for Arduino Nano
BSD 3-Clause "New" or "Revised" License
120 stars 5 forks source link

HowTo Guide #1

Open te-ce opened 3 years ago

te-ce commented 3 years ago

I really want to build this, but I am really new to this topic. Could you provide a how to build guide? Covering like, where to wire what and how it was packed together and how to install it to arduino?

Aplyard commented 3 years ago

Hello, thank you for your interest. At this moment I am still developing my rev3 which is going to be an AIO board with lipo charging embedded. Unfortunately i dont have a written guide on rev1, but i could try helping you figure it out. Do you have any Arduino & Soldering experience? I guess these are a must to follow my project it;s current state. Maybe in the future when rev3 is finished it would be pretty easy for someone to build it. If you still wanna try, ask me anything. Regards, Alex

On Sat, 13 Mar 2021 at 13:53, T-Coro @.***> wrote:

I really want to build this, but I am really new to this topic. Could you provide a how to build guide? Covering like, where to wire what and how it was packed together and how to install it to arduino?

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/Aplyard/Oled-Clicker/issues/1, or unsubscribe https://github.com/notifications/unsubscribe-auth/AJVPFFVRPQFFLVXWTSC2ATDTDNGZ7ANCNFSM4ZDX2UOQ .

te-ce commented 3 years ago

I know how to solder, and I had a short introduction to arduino years ago. But the only information someone (and me) needs is just, which pin soldered to which pin of which hardware, and then how to flash which data to the arduino, and then its done, right?