Open pavik1994 opened 7 years ago
@ArduCAM
@pavik1994 Hi, Sorry for my later reply. Please connect the camera to 3.3V instead of 5V .
Let us know if you need more help. Regards, ArduCAM support team.
Hi, I connect the camera to 3.3V but still in SPI is 4V or more. What can I do more?
Regards
2017-06-15 2:11 GMT+02:00 supprot notifications@github.com:
@pavik1994 https://github.com/pavik1994 Hi, Sorry for my later reply. Please connect the camera to 3.3V instead of 5V .
Let us know if you need more help. Regards, ArduCAM support team.
— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/ArduCAM/Arduino/issues/212#issuecomment-308592492, or mute the thread https://github.com/notifications/unsubscribe-auth/Abmr5o_L_V7J40KaOdJ_Yt-6nWL_KFIeks5sEHaYgaJpZM4Nzk00 .
Hi, try adding 100 ohm resistors between the SPI lines and ground.
Hi, i have problem with my ArduCAM. I connect with RaspberryPi and level voltage in SPI is higher than 3 V. When camera is connect with RaspberryPi in SPI pin is 3V3 but when I started program this level up to 4 V. What can I do with this? This problem is with power camera woth 5V and 3V3. I tried use camera in few RaspberryPi so this isn't problem with RaspberryPi. Thank you for help :)