Got Bad Lidar Health and couldn't find RNGFND_LANDING

ArduPilot / ardupilot_wiki

Repository for ArduPilot wiki issues and wiki-specific website infrastructure.

Other

506 stars 1.26k forks source link

Got Bad Lidar Health and couldn't find RNGFND_LANDING #1375

Closed cyc607 closed 5 years ago

cyc607 commented 6 years ago

Rangefinders (landing page) -

I use ArduRover v3.4.2 and pixhawk with RPLidar A2. When I connect 5v and GND to telem1 the voltage decrease from 5v to 0v. So I only connect RX TX on pixhawk and 5v GND MotorCTL is from another power supply. I always get bad lidar health on mission planner and can't find RNGFND_LANDING parameter.

vierfuffzig commented 5 years ago

RNGFND_LANDING parameter is plane specific, so is the respective note on the rangefinder landing page. you only see it if you access that page from arduplane wiki.

rmackay9 commented 5 years ago

This definitely looks like a support issue so this should go to the rover forums. I think I will close this issue.