Closed Dycus closed 1 month ago
Moonraker pulls the print data stored in job history from Klipper. It appears that you are using a fork of Klipper, so I would recommend attempting to reproduce with pristine Klipper. If you are able to do so you can report the issue on the Klipper Discourse.
As there has been no further feedback I'm going to close this. If the problem can be reproduced on the official Klipper repo this can be reopened and I will investigate further.
What happened
On the Fluidd print history page, all prints have a correct “total duration”. Prints using T0 also have correct "print duration" and "used filament". But prints that use T1 almost always have 0m 0s for print duration, and 0.0mm (or sometimes nonsense, even negative numbers) for used filament. On occasion, a T1 print will show a correct total duration, but the filament used is still wrong. (A recent print shows 2h 27m 6s / 2h 34m 30s / 58.2 mm for print duration / total duration / filament used. I promise more than 58mm of filament were used in this 2.5hr print.)
I have a dual-extrusion printer (Replicator 2X). I pretty much only use only one tool in a print. I haven't tested this behavior with a dual-extrusion print yet.
I initially reported this issue to the Fluidd team, but they say they pull this data directly from Moonraker and so forwarded me here.
Client
Fluidd
Browser
Firefox
How to reproduce
Run a print that uses only T1 (or probably any non-T0 tool) and check the print statistics/history page once finished.
Additional information
moonraker.log klippy.log