To provide greater strength at the mouth of each let ESPECIALLY for legs printed where the layers are horizontal along the leg edge, we will add an endcap. This cap serves 2 purposes. 1. Strength because the cap will be printed on a different plane than the leg so the strands will be much stronger. 2. Identification. Printing these caps will be done on a two color printer so the letters and numbers will really pop.
[ ] when generating joint STL's, also generate a labeled unique end cap for each leg.
[ ] Each cap will have the letters and numbers on all 4 sides (XX-99.9)
35.5 I used for outside dimension
27.8 was a really good fit for then inside hole dimension
20.0 was the hole in the inner side I used.
The cap will add extra strength here at the beginning of a split.
To provide greater strength at the mouth of each let ESPECIALLY for legs printed where the layers are horizontal along the leg edge, we will add an endcap. This cap serves 2 purposes. 1. Strength because the cap will be printed on a different plane than the leg so the strands will be much stronger. 2. Identification. Printing these caps will be done on a two color printer so the letters and numbers will really pop.
35.5 I used for outside dimension 27.8 was a really good fit for then inside hole dimension 20.0 was the hole in the inner side I used.
The cap will add extra strength here at the beginning of a split.