search

Arthrimus / Wii-HDMI

GNU General Public License v3.0
63 stars 4 forks source link

Losing Composite Video when installing Wii-HDMI #8

Open Orcut opened 3 years ago

Orcut commented 3 years ago

When I install Wii-HDMI 0.4, I am losing composite video. I know in the main description it says the Wii-HDMI is similar to Wii Dual, but that it only does HDMI. So I was thinking that it just doesn't support the component features that the Wii Dual has. Does anyone know if losing composite is a normal thing that happens? If so, is there a way to get it working again?

drandreas commented 3 years ago

I don't have any devices with analog input at hand. However if you set "Allow 480p mode" to off than composite should work like no Wii-HDMI was installed: VWudjrn

In all cases component should work like before the install.

Orcut commented 3 years ago

Thank you for your input. I just tried turning off "Allow 480p mode" and it did not work unfortunately. If component should work like before the install as you said, then shouldn't composite work as well?

drandreas commented 3 years ago

I've checked the v0.4 PCB. Pin 8 is tied to 3.3V (Pin 10). The Wii will therefore always assume that the console is connected to a TV using a component cable. I’m sorry for suggesting Allow 480p mode. I now know, that it has no effect when used on a v0.4 PCB of this repo. You can try to break the trace with an exacto knife (on top and bottom layer) to enable composite: PCB

Alternatively try to break trace 8 somewhere along the path. av_port