search

AsherGlick / Charliecube

A 4x4x4 tricolor LED cube with only 16 pins
BSD 2-Clause "Simplified" License
17 stars 15 forks source link

pins at arduino #2

Closed jonnyfalconetti closed 12 years ago

jonnyfalconetti commented 12 years ago

hey there, great projekt. can you please tell me which group is connected to which pin at the arduino? my hardwarepart is ready but it's hard to find the right pins...

regards jonny

jonnyfalconetti commented 12 years ago

could you please tell us which pin is connected to which group? i'm not the only one with this problem: http://hackaday.com/2012/01/07/minimalist-rgb-led-cube-has-a-very-short-bom/#comments (comments)

thanks

AsherGlick commented 12 years ago

I apologise for not getting to this sooner. It has now been fixed and can be viewed on the website aglick.com/charliecube the wires are colour coded and there is a chart matching the colours to the Arduino pins and the AVR pins

jonnyfalconetti commented 12 years ago

thanks a lot :)

jonnyfalconetti commented 12 years ago

you've changed the entire wiring layout, don't you?

AsherGlick commented 12 years ago

I have not changed the entire layout, I have changed the colours of the wire and the fourth section is rotated 90 degrees however the old wiring scheme will work as well. I changed the colours so that they would better match up with the ID colours in the table. If you would like to see the old diagrams you can go to aglick.com/charliecubeold.html. If the documentation is still too confusing I will continue to work on it until it makes sense.

jonnyfalconetti commented 12 years ago

works like a charme with the new wiring, thanks a lot :)

http://www.youtube.com/watch?v=eaxJQpWh0MY