Why it says not constrained although I constrained J4

[tanzinaakther]

Hi, I have constrained photolysis rate but when I run the model, I see the attached note. that means, photolysis rate is not constrained. I checked everything. J1 & J4 is there. Still why i get this.

? any idea?

[tanzinaakther]

[tanzinaakther]

[rs028]

Does the executable point to the right directory?

[tanzinaakther]

Yes

[tanzinaakther]

Please see attached. I am getting the output but model is not getting J4

[rs028]

Is the model constrained to J1?

[tanzinaakther]

Yes. J1 & J4 is constrained

[rs028]

You have J1 and J4 in the photolysisConstrained.config file and the related files in constraints/photolysis/. Is the model reading and constraining J1? or neither?

[tanzinaakther]

Yes, I have. I attached screenshot in the previous comments that I have these in proper directory. Model is not constraining J1 & J4. It says no photolysis constraints file exist although it is there.

[rs028]

do the J1 and J4 files have an extension? sometimes a .txt is added if you create them in windows but you can't see if the file manager hides the extension

[tanzinaakther]

Ok , Right now I can't check. So, I will get back to you after checking

[rs028]

Okay, please close the issue if the problem is solved.

[tanzinaakther]

I checked. There is no extension.

[rs028]

I can't see a reason why this may happen. It works fine on my system. Have you tried to do constrain photolysis rates before? If so, did it work?

[tanzinaakther]

I faced this issue but one of my friends did in his model, it was ok for him. Can I give you my J1 & J4 so that you can have a look?

[rs028]

Sure sent it to me by email : rob.sommariva @ gmail.com

[tanzinaakther]

Hi, I copied my files to my friend's one and then ran. It worked now. But I don't understand what the problem in my folders was.