Multiple Scanlist issue - some channels omited from scan

[N1ckred]

Am using v00.07

Love this firmware version. Great features for the scanner enthusiast. Thanks for sharing. I however have found an issue that some memory channels are omitted from the scan should I have multiple scanlists enabled. This is the scenario...

• Scanlist 8 contains memory channels M1, M2, M3, M4, M197, M198, M199, M200.
• Scanlist 9 contains memory channels M100, M101, M102, M103.
• Note that Scanlist 8 contains memory channels that are numbered below and above the memory channels in Scanlist 9.
• If I have only Scanlist 8 enabled, the scan cycles through all the memory channels on scanlist 8 as expected.
• If I have only Scanlist 9 enabled, the scan cycles through all the memory channels on scanlist 9 as expected.
• If, however, I enable both scanlist 8 and 9. The scan goes through all scanlist 8 memory channels, then all Scanlist 9 memory channels but when it goes back to scanlist 8 it starts at the memory channel in scanlist above the highest scanlist 9 memory channel that it had just scanned i.e. in my example it starts from M197. It has therefore omitted M1, M2, M3 and M4 from scanlist 8. As the scan continues it will just cycle through as follows M100, M101, M102, M103, M197, M198, M199, M200, M100, M101, M102, M103, M197, M198, M199, M200 ...
• It never again scans M1, M2, M3 & M4 from Scanlist 8.

Hope this makes sense. I repeated this using other scanlists and different memory channels and it consistently behaved this way should one of the "enabled" scanlists have memory channels both below and above the memory channels contained in the second enabled scanlist ! I also looked to see if the frequencies contained in the memory channels in the scanlist affected this behaviour but I don't think its frequency dependant.

I was wondering if you have seen this behaviour before and if there was maybe a work around ?

[jflinchbaugh]

I need to check my notes, but I think I may have seen something like this. I'll try a reproduction or an alternate reproduction. I had worked around it by shuffling some channels around.

[AubsUK]

I think it may be the same as this?

https://github.com/AubsUK/uv-k5-firmware-custom/issues/22

But please make sure you do a factory reset after installing the fork.