search

BETAFPV / BETAFPV_Configurator

GNU General Public License v3.0
83 stars 11 forks source link

No OSD on Cetus PRO after Flash FC #7

Closed m4rc1no5 closed 2 years ago

m4rc1no5 commented 2 years ago

Hello,

After flash firmware (1.1.1 or 1.1.2) on Cetus PRO I don't see any information (about fly time, mode, battery voltage) on the screen. There is only a raw view from the camera. Could you help me and tell me what I should do to enable this information - I don't see this option in BETAFPV Configurator (v1.1.0_RC1).

Best regards, Marcin Zaremba

m4rc1no5 commented 2 years ago

I tested firmware 1.1.1 and 1.1.2 and I use BETAFPV Configurator on macOS. Thanks.

HWT662988 commented 2 years ago

Did the OSD work properly before you updated the new firmware?and could you tell me your FC's hardware version (such as 'lite 1-2S Pro1.1' or 'Cetus pro1.2')which you can see on flight control board? Thanks.

m4rc1no5 commented 2 years ago

Hi,

The OSD worked properly before the update.

I see on the FC version Lite 1-2S Pro V1.0.

Thanks for your fast response. :)

IMG_20211127_101744

HWT662988 commented 2 years ago

hi,Marcin Zaremba. update your OSD firmware with BETAFPV Configurator,the OSD firmware is here: LiteSilverOSD_2021-7-29.zip

m4rc1no5 commented 2 years ago

Hi,

everything works fine after updating OSD firmware - thank you very much for your support! :)

Best regards, Marcin

LeMysticboy commented 2 years ago

@HWT662988 I Have a similar problem. I updatet the FC Firmware to V1.2.2 on my Cetus Pro Brushless. Now i lost the OSD. I tried to flash a new OSD Firmware. but it don't worked. I think i have the wrong OSD firmware.

could you sent me the correct OSD Firmware?

My Setup: Cetus Pro Brushless FC Board V1.2 FC firmware version V1.2.2