search

BeyondRobotix / mavesp8266

ESP8266 WiFi Access Point and MAVLink Bridge
Other
185 stars 172 forks source link

add check password #35

Closed Tanson closed 7 years ago

Tanson commented 7 years ago

The wifi password must be greater than or equal to 8

Sorry, I put the private use of the code submitted.

new request is added help Page, Web AUTH, Web config Page.How can I close it?

dogmaphobic commented 7 years ago

What is this? Why was the README basically wiped out? Why change the SSID? Baud rate?

Tanson commented 7 years ago

SSID just because of personal habits only, if you mind I modified back. Baud rate is because Pixhawk's default speed is 57600, the use of more convenient

dogmaphobic commented 7 years ago

This firmware is being used by a whole lot of people. It would be a very bad idea to change the SSID. The Pixracer default baud rate for the ESP bridge is 921600. Changing it to something else will break everything out there.

pkocmoud commented 7 years ago

@Tanson This was designed for the Pixracer whose wifi telemetry port defaults to 921600, what flight controller are you attempting to connect to?

mzahana commented 7 years ago

I guess the highest baud is much better. Becaus it provides higher throughput .

pkocmoud commented 7 years ago

This has worked well with and for the Pixracer for quite some time.

Tanson commented 7 years ago

Sorry, I put the private use of the code submitted