search

BeyondRobotix / mavesp8266

ESP8266 WiFi Access Point and MAVLink Bridge
Other
182 stars 173 forks source link

WiFi not showing up after flash #73

Open krunal2103 opened 4 years ago

krunal2103 commented 4 years ago

I bought a new ESP-01 to use it with Pixhawk4 running PX4 v1.10.1. The ESP-01 board was running fine as it was publishing a predefined wifi AP out of the box. I then flashed it with the mavesp8266 v1.2.2 firmware. The flash was successful as in there were no errors during the flash process. I then power cycled the ESP-01 with just RX-TX connected to the pixhawk. But, there was no WiFI AP (SSID:pixracer) that was being published.

mbr1989 commented 4 years ago

same here with pixracer

nikonianvicky commented 4 years ago

try changing the SPI mode to QIO