Open pchanon opened 2 years ago
@pchanon: Thanks for opening an issue, it is currently awaiting triage.
The triage/accepted label can be added by foundation members by writing /triage accepted
in a comment.
In the meantime, you can:
The procedure is as follows, whether Nodehub, Allnodes or mydefichain: You get a legacy address as OPERATORADDRESS from your provider (Allnodes) and create your own legacy address in your local wallet (Owneraddress). Then the command in the CLI: createmasternode OWNERADDRESS OPERATORADDRESS Wait 8h until the Masternode is ENABLED and you are done. DO NOT click on ENABLE in the wallet. Just leave it as it is. Do not enter gen=1 or anything else in the local config, it is not necessary. Close wallet, store PC/Laptop in the safe - done :-)
Thankyou I will give it a try. I have just try to resign the wallet first. So I will have to wait for the resign to be finish and try to runthe masternode again right?
Yes, but you need a new Operator and new Owneraddress to create a masternode again.
is it possible to use the resign operator address and my current address? or I have to create new legacy address?
CHANON PATNASIRI *Managing* Director
*Email: @.** Mobile: +66812079046 Adress:* 29/28 Soi Charoennakorn 12, Charoennakorn Rd, Klong Sarn Bangkok 10600, TH
On Thu, Jun 23, 2022 at 8:44 PM Stonygan @.***> wrote:
Yes, but you need a new Operator and new Owneraddress to create a masternode again.
— Reply to this email directly, view it on GitHub https://github.com/DeFiCh/app/issues/1207#issuecomment-1164426158, or unsubscribe https://github.com/notifications/unsubscribe-auth/AYMOBTWJUN37JXB73VO2WW3VQRS2BANCNFSM5ZULIY5Q . You are receiving this because you were mentioned.Message ID: @.***>
No, see one post above. you need both addresses new.
Hi, I can see that my nodes are now enabled. I have waited for 12h now I have not seen my nodes minted any blocks. I may have missed any setting up protocol?
Chanon
On Thu, Jun 23, 2022 at 9:00 PM Stonygan @.***> wrote:
No, see one post above. you need both addresses new.
— Reply to this email directly, view it on GitHub https://github.com/DeFiCh/app/issues/1207#issuecomment-1164444961, or unsubscribe https://github.com/notifications/unsubscribe-auth/AYMOBTRMYOAKFYJGX33DUYDVQRUYNANCNFSM5ZULIY5Q . You are receiving this because you were mentioned.Message ID: @.***>
Hello, I still cannot see my nodes minting any blocks do you have any suggestions?
Average Time to find a Block is ~4,5 days. It can take longer, maybe 14 days for your First Block.
Masternode created with desktop app together with owner's address and operator address. However, the masternode will not run when i tried to enable it and have to go remove gem=1 in the defi.conf file.