Single click: Enables screen switching (only functional with firmware version 1.5 or higher).
Press and hold for 5 seconds: Initiate a reset of your configurations and restarts the device.
Hold and power up: Activates the configuration mode, granting access to modify the current configuration via Wi-Fi or adjust/verify settings.
The option Hold and power up: Activates the configuration mode, granting access to modify the current configuration via Wi-Fi or adjust/verify settings. allows to enter the configuration mode and modify the current configuration. But after saving and the device starts, the new changes aren't persistent.
And this happens in any setting, from the BTC address to the UTC settings. This last one very useful for daylight saving time changes.
The only way to work around this is to do a hard reset, erase all data on the device and configure it all over again.
As in this guide:
https://nerdminers.com/nerdminer-setup-guide/
The option Hold and power up: Activates the configuration mode, granting access to modify the current configuration via Wi-Fi or adjust/verify settings. allows to enter the configuration mode and modify the current configuration. But after saving and the device starts, the new changes aren't persistent.
And this happens in any setting, from the BTC address to the UTC settings. This last one very useful for daylight saving time changes. The only way to work around this is to do a hard reset, erase all data on the device and configure it all over again.