I recently bought a Lilygo T-Display S3 and wanted to flash NerdMiner v2 on it. I flashed using the official online flasher, and the display gets initialized perfectly, but after that, I'm unable to connect to the WiFi network for the board configuration, because I can't see it both from my pc and phone. Here's the serial log output:
19:48:17:649 -> NerdMiner v2 starting......
19:48:20:293 -> SPIFS: Mounting File System...
19:48:20:348 -> SPIFS: Mounted
19:48:20:393 -> SPIFS: No config file available!
19:48:20:395 -> *wm:[ERROR] parameter IDs can only contain alpha numeric chars
19:48:20:395 -> AllDone:
19:48:20:432 -> *wm:StartAP with SSID: NerdMinerAP
19:48:20:933 -> *wm:AP IP address: 192.168.4.1
19:48:20:934 -> Entered Configuration Mode
19:48:20:934 -> Config SSID: NerdMinerAP
19:48:20:934 -> Config IP Address: 192.168.4.1
19:48:20:934 -> *wm:Starting Web Portal
As you can see the board apparently sets up an AP but I am unable to see it from my devices. Even scanning the QR code doesn't work.
I recently bought a Lilygo T-Display S3 and wanted to flash NerdMiner v2 on it. I flashed using the official online flasher, and the display gets initialized perfectly, but after that, I'm unable to connect to the WiFi network for the board configuration, because I can't see it both from my pc and phone. Here's the serial log output:
As you can see the board apparently sets up an AP but I am unable to see it from my devices. Even scanning the QR code doesn't work.