I'm using a MK3S with Bondtech extruder and Bear X axis, when performing a XYZ calibration process (Bondtech firmware 3.9.3-4117) the PINDA probe is offcentered from the first calibration point by 5-10mm in the negative X value, looks like the PINDA probe's offsets aren't correct for this setup. The first time, findind the first calibration point worked for some reason, then the print head crashed against its maximum X postion. Weird.
I've set the Z offset of the PINDA probe using a zip tie, everything runs smoothly, exept for this issue.
Hello !
I'm using a MK3S with Bondtech extruder and Bear X axis, when performing a XYZ calibration process (Bondtech firmware 3.9.3-4117) the PINDA probe is offcentered from the first calibration point by 5-10mm in the negative X value, looks like the PINDA probe's offsets aren't correct for this setup. The first time, findind the first calibration point worked for some reason, then the print head crashed against its maximum X postion. Weird.
I've set the Z offset of the PINDA probe using a zip tie, everything runs smoothly, exept for this issue.
X, Y and Z home offsets are correct.
Thanks !
Emilien.