IDE fails with SVN

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Create simple .pde file
2. Add to svn repo
3. open from explorer

What is the expected output? What do you see instead?

Expected:
  Opened sketch ready for editing, compiling etc.
Actual:
  Fails with error dialogue box.

[Title] Launch4j
[Content] An error occurred while starting the application.

What version of the Arduino software are you using? On what operating
system?  Which Arduino board are you using?

Win 7 32-bit
IDE 0022
TortoiseSVN 1.6.12
  (built on SVN 1.6.15)

Please provide any additional information below.

Also tried opening file from within an open IDE, and got a much more detailed 
error, attached as .txt below.

Original issue reported on code.google.com by abstract...@gmail.com on 13 Feb 2011 at 10:36

Attachments:

• failure.txt

[GoogleCodeExporter]

This is a phase-of-the-moon bug. It's sporadic, from day to day, and I cant 
find a single root cause. Would recommend considering dropping this issue if no 
one else comes forward with similar problems?

Original comment by garethpu...@googlemail.com on 15 Feb 2011 at 9:30

[GoogleCodeExporter]

I had this same problem with IDE version 0022 on Windows Vista, but only with 
one PDE file I made myself then tried to load into the IDE. The file name was 
"4x7segmentLed.pde" in the folder named "4x7segmentLed".  Perhaps the sketch 
name cannot begin with a number? When I renamed the project to 
"Four_by_Seven_Segment_Led", it loaded in the IDE just fine.

Original comment by dottom1...@gmail.com on 6 Nov 2011 at 9:59

[GoogleCodeExporter]

Fixed since 1.5.5

Original comment by federico...@gmail.com on 21 Feb 2014 at 4:23

[GoogleCodeExporter]

Original comment by c.mag...@arduino.cc on 22 Feb 2014 at 7:38

• Changed state: Fixed