search

BotoX / xiaomi-m365-firmware-patcher

Automatize patching of Xiaomi Mijia M365 electric scooter firmware
https://m365.botox.bz
412 stars 108 forks source link

Compatibility with hover-1 #107

Open notsolowki opened 3 years ago

notsolowki commented 3 years ago

I see people saying the hover-1 alpha is very similar to the m365. Could this firmware work for the hover-1 alpha? I have dissembled a hover 1 alpha and have found rx,tx and checked various wires with my oscilloscope.

I was able to manipulate the speedometer with a frequency generator but it wont go higher than 18mph @360mhz. I think there might be 2 processors in this scooter.

If any interest in this scooter I could have plenty of pictures of the hardware.

When I probed the communication wire to the esc from the processor on the handle bars for speedometer and throttle I found what looked like some data transmission not just pwm.

bluegizmo83 commented 3 years ago

I see people saying the hover-1 alpha is very similar to the m365. Could this firmware work for the hover-1 alpha? I have dissembled a hover 1 alpha and have found rx,tx and checked various wires with my oscilloscope.

I was able to manipulate the speedometer with a frequency generator but it wont go higher than 18mph @360mhz. I think there might be 2 processors in this scooter.

If any interest in this scooter I could have plenty of pictures of the hardware.

When I probed the communication wire to the esc from the processor on the handle bars for speedometer and throttle I found what looked like some data transmission not just pwm.

Did you try flashing this firmware to see if it works?

68pishta commented 1 year ago

I got no power function out of the power switch, I confirmed the harness is good and the battery is at 38V. I have 38V on the EN pin of the small dash PCB but I do NOT have 12V on the pin next to it. Where does this 12V power come from?