Breazile / MandoPuter

Electronics to drive a Mandalorian gauntlet
MIT License
43 stars 10 forks source link

Flashing leds on Itsybitsy #21

Open Murray7922 opened 3 months ago

Murray7922 commented 3 months ago

Hi There,

i am attempting to build the prebeskar - mandoputer. with the itsybitsy rp2040 and the 1.14" screen i have followed the guide, but i appear to have run into an issue where all i get is a blank screen and a red flashing LED (2 flashes every 5 seconds) i have tried, downloading a previous version of circuit pyhon, redownloading the release for the itsybitsy and installing the unaltered file onto the drive - however the issue remains. im stummped.

I am able to swap between the bootloader and the drive without any issues, but not entirely sure where i have went wrong.

Desktop (please complete the following information):

Murray7922 commented 3 months ago

done a little more troubleshooting and found this error when using the MU editor - Auto-reload is on. Simply save files over USB to run them or enter REPL to disable.

Press any key to enter the REPL. Use CTRL-D to reload. soft reboot

Auto-reload is on. Simply save files over USB to run them or enter REPL to disable. code.py output: Traceback (most recent call last): File "code.py", line 18, in ValueError: incompatible .mpy file

Code done running.

Press any key to enter the REPL. Use CTRL-D to reload.

Adafruit CircuitPython 9.1.1 on 2024-07-22; Adafruit ItsyBitsy RP2040 with rp2040

Breazile commented 3 weeks ago

Try copying the lib folder again to the board or check the version of CircuitPython you are using. Open boot_out.txt and it will show which version is installed on the board. The current releases are 8.x.x, and I'm currently working on upgrading everything to 9.2.0