Unable to open project

[GoogleCodeExporter]

Hi, I'm trying to open the project and it doesn't do anything. I've downloaded 
all the files from the source (all header files and so on),I've changed the 
compiler to avr-gcc and I've even made the same file hierarchy as in the 
repositorybut I just get a "Opening D:\Hobby\CodeBlocks\wii_esc_ng.cbp" message 
in Codeblocks log and it's like I didn't open anything.
What am I doing wrong? Is there another way or must I make a new project and 
start adding files?

Original issue reported on code.google.com by silviu.d...@gmail.com on 23 Apr 2014 at 12:06

[GoogleCodeExporter]

[deleted comment]

[GoogleCodeExporter]

Figured out the problem, all the files were in HTML format. Redownloaded the 
project with tortoise svn and everything is OK, I can compile the project. Now 
I have another issue, I select the corresponding board (RB50A) and flash 
everything when I power the esc instead of beeps the motor is doing some 
strange moves, like it's hitting something over and over again. If I disable 
the startup sounds the motor (NTM 3530 1400kv) starts with a little help but I 
can only go to 15-20% throttle and after that it stalls. I tried SimonK and 
BLHELI and the motor runs Ok but I have problems with very hard acceleration. 
With WiiESc the motor doesn't even start right and if it starts I have the 
maximum throttle issue.

Original comment by silviu.d...@gmail.com on 2 May 2014 at 5:38

[GoogleCodeExporter]

Hi, can you try pre-compilled HEX from here: 
https://googledrive.com/host/0Bzk5pgkwmev-b3ZLaWdQOEJGWUk/

Original comment by d.kayu...@gmail.com on 15 May 2014 at 4:45

[GoogleCodeExporter]

Hi, thanks for the reply but I forgot to mention one thing: I have a DIY ESC 
and the wiring is similar to the RB50A but the high side and low side signals 
are reversed so I cannot use a predefined hex file.

Original comment by silviu.d...@gmail.com on 15 May 2014 at 6:17