Gimbal does not work on Crius AIO pro board

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Setup gimbal in mission planner
2. In mission planner I can not set up angles on any channel RC5-RC11
3. Connect two servos on pins d44 and d45

What is the expected output? What do you see instead?

Gimbal working with gain setup.

What version of the product are you using? On what operating system?

2.7 R4

Please provide any additional information below.

I am using Crius AIO pro board and analog or digital servo, I tried both.

Original issue reported on code.google.com by mato...@gmail.com on 20 Sep 2012 at 7:17

[GoogleCodeExporter]

I have the exact same problem

Original comment by mop98...@gmail.com on 9 Oct 2012 at 1:29

[GoogleCodeExporter]

Check this, it should help :-)

http://www.multikopter.co.uk/forum/index.php/topic/563-crius-aio-pro-megapirate-
and-a-camera-gimbal/

Original comment by mato...@gmail.com on 9 Oct 2012 at 1:36

[GoogleCodeExporter]

Thanks. Perfect

Original comment by mop98...@gmail.com on 9 Oct 2012 at 1:58

[GoogleCodeExporter]

the link is death. please can you give me the solution?

Original comment by sia...@gmail.com on 31 Oct 2012 at 2:53

[GoogleCodeExporter]

Isnt dead, you have to be registered only.

Original comment by mato...@gmail.com on 31 Oct 2012 at 6:42

[GoogleCodeExporter]

I'm tried 2.8R2 and seems all works fine. (I'm connected just two servos since 
I'm have no Camera Mount)

Original comment by Alexey.K...@gmail.com on 28 Dec 2012 at 11:48

• Changed state: WontFix

[GoogleCodeExporter]

Works great! With the Crius AIO Pro when the the yellow jumper is removed for 
external power one red lead from an esc must still remain connected for the 
servos to have power. The settings must be done in advanced settings and not in 
the camera window.

Original comment by andyho...@gmail.com on 4 Jan 2013 at 4:42

[GoogleCodeExporter]

I checked that thread and I can't get it working. I have power to the servos 
but can only get tilt to work and only if I assign it to RC_6. With MultiWii It 
works and I can turn it on in config and not tie up an RC channel to use the 
gimbal. Is there a list of the steps in one place to enable the gimbal for both 
tilt and roll and not use a radio channel to do this? Thanks 

Original comment by ebour...@gmail.com on 16 Apr 2013 at 6:40

[GoogleCodeExporter]

I have the same problem of ebour...@gmail.com

Original comment by fabrici...@gmail.com on 27 Jun 2013 at 6:04