Open willyhabr opened 5 months ago
I think this is not a update problem. Do you have bl Touch or the origin 3D Touch
bl Touch, only happens when doing z-tilt and when doing the second touch for alignment
Can you make a video and send it to me. What does the printer and wat write the terminal
Sending video, sorry for aspect...
https://github.com/Bully85/Sovol-SV04-Klipper/assets/30597866/7fd674c7-929d-412c-b3a4-8ab9ca9ada96
Ok adjust your bed first use the plastic stick for the gantry than adjust your screws of your bed if this ready try again
Hi Bully, the adjusts did not solve the problem, but I was browsing at printer.cfg and changed: stow_on_each_sample: true was false I changed to true, and everything is working perfect
Ok thanks for feedback if more have the same problem I change it. For first time I have look on this
Thank you, you have done a great job. One question: The issue of displaying strange characters in the remaining time has a solution?
Can you send a photo what you mean
Actually I got this at Facebook Klipper test. You posted it.
Can confirm that I was also having the exact same issue. Failed on the second probe during z-tilt, right after the update.
The above fix did work for what it's worth.
Are you sure to select the right z settings for chip?
Are you sure to select the right z settings for chip?
Amusingly I was using the old Printer.CFG as I was working to transfer over the chip settings that were working. So yes, they're the same chip settings that I was using previously. But after the update those settings started giving me this issue, and after applying the above fix it was magically resolved.
Was working without issue for well over 9mo until the update.
Can you describe your problem in detail and send me excerpts from the cfg and screenshots?
Can you describe your problem in detail and send me excerpts from the cfg and screenshots?
Normally I would have no problem providing you all of that, however! In attempting to solve another problem, I updated the firmware with your latest release, and I have not been able to get clipper to reconnect the printer since. I even reinstalled the entire pi environment.
So my apologies, I cannot get you that information.
I did the update that was avaible at update manage, since that a can't print anymore because of bltouch fail to deploy: Is there an way to fix it? Thanks 16:45 Failed to verify BLTouch probe is raised; retrying. 16:45 BLTouch failed to deploy 16:45 probe at 280.000,150.500 is z=1.454000 16:45 probe at 50.000,150.500 is z=1.261500 16:45 probe at 50.000,150.500 is z=1.261500 16:45 Z_TILT_ADJUST