Enhancement - Change parameters with spare TX channel.

CCAZE31 / ardupilot-mega

Automatically exported from code.google.com/p/ardupilot-mega

0 stars 0 forks source link

Enhancement - Change parameters with spare TX channel. #827

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago

If flying alone, it can be quite difficult operating a laptop in the field to 
tune PIDs etc. Would it be possible, before a flight to assign a spare RX 
channel to a certain parameter, specify a range (eg Roll servo P 0.4 – 1.2) 
and use the TX to adjust the value? Perhaps either with a TX switch to  step up 
the parameter or using a TX slider/knob.
Thanks.

Original issue reported on code.google.com by rvinceh...@googlemail.com on 17 Dec 2012 at 4:28

GoogleCodeExporter commented 8 years ago

I have just acquired a quadcopter and see that this feature is already in the 
Arducopter software. Its very useful, can we please have it on Arduplane.

Original comment by rvinceh...@googlemail.com on 29 Dec 2012 at 6:00