Closed tmoriyam closed 4 years ago
@tmoriyam hello , did you finished 3D openpose setup?
not xet... - Tsuyoshi
2019年9月25日(水) 10:26 eng100200 notifications@github.com:
@tmoriyam https://github.com/tmoriyam hello , did you finished 3D openpose setup?
— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/CMU-Perceptual-Computing-Lab/openpose/issues/1376?email_source=notifications&email_token=ADCUASC5XS3PQPBRGZF5ITDQLK44ZA5CNFSM4IXX3QNKYY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOD7QJDOY#issuecomment-534811067, or mute the thread https://github.com/notifications/unsubscribe-auth/ADCUASC3AS3X7M4XNK3TNDTQLK44ZANCNFSM4IXX3QNA .
-- 森山 剛
@tmoriyam can you provide me your email, my email is sm_Adnan21@hotmail.com
It's pretty straightforward: Connect the cameras to the PCI card of the PC via the USB cables.
Dear Gines,
Thank you for your input. You mean the power and the synchronization signal for letting those cameras (four cameras, right?) capture images every synchronized moment and send the images to the PC are supplied by the computer, correct?
Tsuyoshi
Power: Yes. Synch: We use the Flir software synch, so also yes. If you need higher precision, hardware sync should be better in theory, but sw one was sufficient in our cases.
Hi @gineshidalgo99 we have a setup of 4 Flir cameras using ethernet cables + port which is connected to our computer. Are we able to run OpenPose 3D reconstruction including the software triggering with this setup or is USB cable input required?
Thanks and best, Sebastian
I am planning to setup the camera system for 3D openpose. If anyone would give me any information of how to connect cameras and computers, it will be highly appreciated.
Best wishes, Tsuyoshi