Document steps to fabricate open water level sensors and put in a .md file in appropriate location
Here's a rough draft
Chop 1.5” sch-40 pvc into 8” sections (nb: may want shorter so that cables reach)
Drill 9/64” hole 5 cm from top of pvc
3D print top end cap, sand
3D print bottom end cap, sand
Re-tap NPT threads
Cut solar panel cable terminator
Pass solar cable into pvc, taking care to give enough slack inside to make connection/solder to microUSB connector and enough outside to be able to maneuver solar panel onto top end cap
Document steps to fabricate open water level sensors and put in a .md file in appropriate location Here's a rough draft