cal0blank=1

[deejay87]

Setup atmosphere with exosphere.ini

blank_prodinfo_emummc=1

Try with/without setup in hekate_ipl.ini cal0blank=1

Launch CFW(EMUMMC) Result Don't change the serial number (Work if i start fusee-primary)

[CTCaer]

Redownload the release zip.

This was fixed with https://github.com/CTCaer/hekate/commit/da8c040c082ec4fc23bab6327400075508fb5646 I forgot to push that change and without that, sd card is getting unmounted and then it tries to reach the exosphere.ini and it fails.

You might need to replace your reboot_payload.bin also or where else hekate is copied

EDIT: I'll keep the issue open so the people that downloaded 2 hours before, can see that.

[deejay87]

i have test again with the new hekate_ctcaer_5.2.0.bin and it's the same problem the other files in the sys folder are the same

[CTCaer]

What did you try exactly? show me your hekate ini

[deejay87]

[config]
autoboot=0
autoboot_list=0
bootwait=1
verification=1
backlight=100
autohosoff=0
autonogc=1
cal0blank=1

{--- Custom Firmware ---}
[CFW (EMUMMC)]
fss0=atmosphere/fusee-secondary.bin
kip1patch=nosigchk
atmosphere=1
logopath=bootloader/bootlogo.bmp
icon=bootloader/res/icon_payload.bmp
kip1=atmosphere/kips/*
{}

and exosphere.ini

[exosphere]
blank_prodinfo_emummc=1

[deejay87]

oh, i have make a fresh install with 2 emummc and now it's ok,

[CTCaer]

have in mind that the keys in exosphere.ini do not interchange. If you only have blank_prodinfo_emummc it doesn;t work for sys and if you only have blank_prodinfo_sysmmc it doesn't work on emummc.

[deejay87]

it's exactly what i have write in the setup i show you, i'm going to try today and continue somes tests :+1: I understand exosphere.ini work on launch fusee-primary and setup cal0blank=1 do the job with launch > cfw(emummc), i'ts the tests i do, and control the serial is with 0000000000