search

CanUnesi / QMK-on-K6

Instructions for running QMK on Keychron K6 RGB
121 stars 14 forks source link

Not detected by VIA #3

Open jbking93-git opened 2 years ago

jbking93-git commented 2 years ago

Hello, thank you so much for this guide!

I flashed the pre-compiled "keychron_k6_rgb_via_ansi" VIA enabled firmware - it successfully flashed (I know because some of the FN key mapping is different, and there are RGB layouts that aren't in the stock firmware.)

However upon opening up VIA, the keyboard is not detected. I downloaded the Keymap and loaded it in the Design tab, but still no luck. What have I done wrong?

CanUnesi commented 2 years ago

You should import the . json file, not the Keymap.c

On Mon, Feb 28, 2022, 18:51 jbking93-git @.***> wrote:

Hello, thank you so much for this guide!

I flashed the pre-compiled "keychron_k6_rgb_via_ansi" VIA enabled firmware

  • it successfully flashed (I know because some of the FN key mapping is different, and there are RGB layouts that aren't in the stock firmware.)

However upon opening up VIA, the keyboard is not detected. I downloaded the Keymap and loaded it in the Design tab, but still no luck. What have I done wrong?

— Reply to this email directly, view it on GitHub https://github.com/CanUnesi/QMK-on-K6/issues/3, or unsubscribe https://github.com/notifications/unsubscribe-auth/ASFY36S5EAOITJN6APHWJFDU5TTRZANCNFSM5PRO4OMQ . You are receiving this because you are subscribed to this thread.Message ID: @.***>

FreedomString commented 1 year ago

I have a the same problem as @jbking93-git. Trying to import the .json file only results in a freeze of VIA. Does anybody else have this problem specifically with the K6, or is this just a general problem between Keychron and VIA.