c-bash
commented
1 month ago This is the breadboard to be replaced on each platform. See more information on this board here.
The circuit for the thruster actuation is shown in part here, which can be found under the Power Systems wiki page.
The MOSFETs should not be soldered directly to the board since sometimes these components get damaged and must be replaced. Instead, they should be connected through a female header connector (such as this, note, this specific connector has not be confirmed to be compatible with the dimensions of the MOSFET).
The MOSFETS used in the current design must be carried over to the new design---in other words, the PSMN022-30PL,127 must be used.
Most components (e.g., MOSFETS, some connectors, resistors) have been ordered by last year's capstone team. These components can be found in the WIRING drawer of the lab. I believe all these components are through-hole. If surface mount components are desired (e.g., resistors), these must be ordered.
sean-charlton
An open task from last year that was not accomplished. Needs to replace the solderless breadboard on each platform with a (more permanent) PCB. Design needs to be reviewed by the admin team before any submissions for manufacturing.