Open SergeBakharev opened 2 weeks ago
Currently when auto leveling is enabled the machine probes an area using G32 over the area encompassing the tool paths.
G32
It would be nice to be able to adjust the area that is probed to be a subset of the toolpath region.
A common scenario is needing to avoid clamps on top of the stock, or cases where the toolpaths might be off the stock (eg facing).
Auto - level changes
SergeBakharev
commented
2 weeks ago SergeBakharev
commented
2 weeks ago 
Currently when auto leveling is enabled the machine probes an area using
G32over the area encompassing the tool paths.It would be nice to be able to adjust the area that is probed to be a subset of the toolpath region.
A common scenario is needing to avoid clamps on top of the stock, or cases where the toolpaths might be off the stock (eg facing).