Battery discharge/charge % incorrect in eVic VTwo (inbuilt battery)

ClockSelect / myevic

This is myevic Custom Firmware.

GNU General Public License v3.0

299 stars 101 forks source link

Battery discharge/charge % incorrect in eVic VTwo (inbuilt battery) #310

Closed adid45 closed 6 years ago

adid45 commented 7 years ago

I have set the battery to "generic" in the expert section but sometimes the battery % starts discharging rapidly (like 4% per drag) until it reaches zero. After connecting it to the charger the battery % increases quickly to level which it was before starting to discharge at this high rate.

I am using an Evic Vtwo @35W on 0.2ohm coils.

ClockSelect commented 6 years ago

The VTwo battery profile hasn't been taken into account; I'll fix that.

But it won't solve your problem if your battery is dead. With the generic battery profile, the VTwo should seem to drain slower, not faster.

adid45 commented 6 years ago

The battery is alright, I am still using it on stock firmware.

I will test again this weekend.

ClockSelect commented 6 years ago

No news, good news.