I ran a manual backup to test this new plugin (I uninstalled the old appdata backup plugin as I realized it was no longer working for 6.12 and installed the current one today (2023.09.27). I'm on 6.12.3.
It stopped, backed up and started 2 containers so far, but then seemed to hang on a relatively small container after that, so I clicked on the Abort button in the Status/Log page, and it still says the backup is 'Running'. Is there a way to manually kill it, and I'm assuming this isn't normal behavior?
Issue was on my end. Needed to reboot unraid to get it responding again. Haven't tried to abort a backup again, but nobody else is mentioning this as an issue, so I'll assume the abort button works.
I ran a manual backup to test this new plugin (I uninstalled the old appdata backup plugin as I realized it was no longer working for 6.12 and installed the current one today (2023.09.27). I'm on 6.12.3.
It stopped, backed up and started 2 containers so far, but then seemed to hang on a relatively small container after that, so I clicked on the Abort button in the Status/Log page, and it still says the backup is 'Running'. Is there a way to manually kill it, and I'm assuming this isn't normal behavior?
Thank you.