Problem with 2x workers with plow/subsoiler not lifting tool

[bojanh66]

I create course for 2x workers on same field with subsoilers. 2 headlands and up/down rows. Once they finish 2nd headland and continue to 1st up/down row, they wont lift tool, but continue driving with lowered tool, which can take few minutes until they reach 1st up/down row, especially on big fields. I tested with only 1 worker and it works good, so problem is with 2x workers.

[Tensuko]

logfile with channel 6 12 and 14

[bojanh66]

log.txt

[bojanh66]

Also here is another "issue" which happens with 2x tools and Activated Use pathfinding in turns.

https://youtu.be/zsbQaf5-tEE

With deactivated , it works fine...but i prefer to have this option activated because it helps with sprayers when going from one to another row, but in this case with 2x tools, it is causing a small issue where worker goes whole circle around the field for the next row.

[magicmana]

if can help i have the same problem with 2 combine using convoy : https://www.youtube.com/watch?v=tgxvjV3nyoI at one moment the right combine start to use headland for go to next point.

[Tensuko]

logfile with channel 6 12 and 14

@magicmana

[magicmana]

log.txt done

[magicmana]

had the bug again on a combine and with a tractor with a plow too , each time was the vehicle who are define to work at right (asymetric) i tryed to edit the course and is appear that moving the green point reproduce the bug. i made some try with some other green point on the course, and when you move a lot the position of any green point , the vehicle start to chose the wrong direction.

[Tensuko]

Should be fixed long ago. If not make a new Issue with new logfiles pls.