I replaced my stock extruder on my ender 3v2 with a biqu h2 direct drive the cable was too short so I used the stock cable . I believe the pinout connections of the H2 stepper motor are different than the stock 42-40 motor. has anybody had the same problem ?.I need the pinout of the mainboard extruder pins so I get the a+,a-,b+,b-, correct. I believe that I damaged the stepper driver when I used the stock cable when i hooked up the old 42-40 stepper it stutters .
I replaced my stock extruder on my ender 3v2 with a biqu h2 direct drive the cable was too short so I used the stock cable . I believe the pinout connections of the H2 stepper motor are different than the stock 42-40 motor. has anybody had the same problem ?.I need the pinout of the mainboard extruder pins so I get the a+,a-,b+,b-, correct. I believe that I damaged the stepper driver when I used the stock cable when i hooked up the old 42-40 stepper it stutters .