My issue: My Ender 3 V2 (Mainboard v4.2.2), Z output Stop working.
I believe that the problem is on the main board once I have already checked cabling, motor and mechanics eliminating the possibilities out of main board.
I have also uploaded new jyers firmware to eliminate any software issue.
Practically speaking: Z output is Dead. I did not measured if it is 100% dead or not. Because I did not connected the oscilloscope into the output pins yet, once I do not know yet what to expect with the measurements.
I would like to fix it before consider change the main board. Probably there are any driver's protection component opened.
Please anyone have the circuit diagram? Or any information that can help me debugging this issue?
Hi everyone,
My issue: My Ender 3 V2 (Mainboard v4.2.2), Z output Stop working.
I believe that the problem is on the main board once I have already checked cabling, motor and mechanics eliminating the possibilities out of main board.
I have also uploaded new jyers firmware to eliminate any software issue.
Practically speaking: Z output is Dead. I did not measured if it is 100% dead or not. Because I did not connected the oscilloscope into the output pins yet, once I do not know yet what to expect with the measurements.
I would like to fix it before consider change the main board. Probably there are any driver's protection component opened.
Please anyone have the circuit diagram? Or any information that can help me debugging this issue?
Thank you very much in advanced.
Alcides