CrealityOfficial / CrealityPrint

GNU General Public License v3.0
162 stars 24 forks source link

Arachne Wall Generator Broken #98

Closed frankt2012 closed 1 month ago

frankt2012 commented 1 month ago

Seems to be a overhang issue with arachne in 5.0. When I print a bency the bow of the boat comes out horrible and when I print in classic mode it is fine. Also corners of the benchy curl with arachne. The strange part is I did not have any problems with the alpha version and arachne. Screenshot 2024-05-02 211825 The one on the left is printed with arachne

frankt2012 commented 1 month ago

I think I figured out the problem. It is not the slicer or Arachne. It seems to be the filament I am using. Seems Inland high speed PLA is not as high speed as it should be. But this filament does print better with classic wall generator. I don't know why. I guess Hyper PLA profile is no good for this stuff. Going to have to run full calibration test on this stuff. I wonder if it has a lower volumetric pressure then Hyper PLA. Maybe it is hitting its limit. Going to do more test on this.

frankt2012 commented 1 month ago

I have confirmed it was the Inland high speed filament that was the problem. It does not like a layer time of 4 seconds. Had to up it to 6.