search

CrealityOfficial / K1_Series_Annex

GNU General Public License v2.0
156 stars 25 forks source link

Input shaping broken #8

Open alientek opened 9 months ago

alientek commented 9 months ago

Calibration takes the Y value and copies it to the X axis.

Fix: calibrate each axis independently.

e-dreyer commented 9 months ago

This page shows a fix for this:

https://github.com/Guilouz/Creality-K1-and-K1-Max/wiki/Fix-issue-with-Input-Shaper

alientek commented 9 months ago

This page shows a fix for this:

https://github.com/Guilouz/Creality-K1-and-K1-Max/wiki/Fix-issue-with-Input-Shaper

I'm aware, but it should be fixed in the default firmware. That's why I created a bug here.

e-dreyer commented 9 months ago

This page shows a fix for this:

https://github.com/Guilouz/Creality-K1-and-K1-Max/wiki/Fix-issue-with-Input-Shaper

I'm aware, but it should be fixed in the default firmware. That's why I created a bug here.

I agree. Just wasn't sure if you knew about this temporary fix.

e-dreyer commented 9 months ago

@alientek However, I think this isn't the best place to create this issue. We need to create it in the Klipper fork by Creality for the K1. No Klipper config is listed in this repo for me to possibly correct and create a pull request.

alientek commented 9 months ago

@alientek However, I think this isn't the best place to create this issue. We need to create it in the Klipper fork by Creality for the K1. No Klipper config is listed in this repo for me to possibly correct and create a pull request.

I'm not sure where to create this correctly, could you create the issue on the correct repository?

e-dreyer commented 9 months ago

@alientek However, I think this isn't the best place to create this issue. We need to create it in the Klipper fork by Creality for the K1. No Klipper config is listed in this repo for me to possibly correct and create a pull request.

I'm not sure where to create this correctly, could you create the issue on the correct repository?

I actually waited for the official updated and did not use the root work around. I just installed the 1.3.2.20 version and checked. It seems as if they implemented all corrections made by the respository I listed. What version are you running?

I am on the K1, btw.

beatwinthewave commented 9 months ago

https://www.reddit.com/r/crealityk1/comments/17zvrfo/input_shaping_xy/