Errors in the manual Guide/Cyclops Manual v1.5.pdf

D3vil-Design / Cyclops-Extruder

The D3vil Designs "Cyclops" extruder was specifically engineered to address issues associated with the stock Creality K1 / K1 Max extruder. Not only is the Cyclops a seamless direct drop-in upgrade, but it also draws on proven technology from the Orbiter 2 project.

30 stars 1 forks source link

Errors in the manual Guide/Cyclops Manual v1.5.pdf #1

Open NAPCAL opened 5 months ago

NAPCAL commented 5 months ago

Page 3 MR128 bearing (ID 8.0mm x OD 12.0mm x 3.5mm) The kit provides an MR128 bearing (ID 8.0mm, OD 12.0mm x 2.5mm). You can find both types, but most 2.5mm versions will be open without shielding.

Pages 16-18 These show a drive gear with a grub/set screw hole, but the one provided in the kit is a type with no grub/set screw hole; this may confuse some builders.

DerrickDarrell commented 5 months ago

We'll look into this, thanks

epicteammate commented 5 months ago

To add to this post, perhaps this is just limited to myself:

Page 29 The "!" was not necessary for my printer, it caused everything to go backwards when I tested it loading/unloading and extruding/retracting. I haven't fully assembled it yet cause my PTFE tubing got lost in transit but that was my testing while hooked up and running the commands via Guppy screen.