Beta Test Results:

[peteGSX]

Testing configuration

• CommandStation-EX version: 4.0.2
• Turntable-EX version: 0.4.0-Beta
• Microcontroller: Arduino Nano v3
• Stepper driver: ULN2003
• Stepper motor: 28BYJ-48
• Homing sensor: Hall effect (turntable), micro switches (traverser)
• Dual relay board: Keyestudio

If you have edited config.h in Turntable-EX or myHalcpp or myAutomation.h in CommandStation-EX, please upload those to this issue also.

Test 1 - Startup Sequence

Pass

Any observations or comments:

Test 2 - Turntable-EX is Available

Pass

Any observations or comments:

Test 3 - Basic Movement with Automatic Phase Switching

Test 3, Part 1 - Clockwise

Pass

Any observations or comments:

Test 3, Part 2 - Counter Clockwise

Pass

Any observations or comments:

Test 4 - Homing

Pass

Any observations or comments: Also disabled HOME sensor and confirmed homing failed and turntable stopped as designed.

Test 5 - Calibration

Pass

Any observations or comments: Also disabled HOME sensor and confirmed homing failed, and the calibration sequence was not initiated as designed.

Test 6 - LED Output Testing

Pass

Any observations or comments:

Test 7 - Accessory Output Testing

Pass

Any observations or comments:

Test 8 - Manual Phase Switching

Pass

Any observations or comments:

Test 9 - Sensor Testing

Pass

Any observations or comments: Tested in TRAVERSER mode.

Test 10 - Traverser Mode

Pass

Any observations or comments:

General comments or feedback

Please share any general comments or feedback here:

[peteGSX]

Regression testing succeeded, ready to release 0.4.0-Beta.