Beta Test Results: v0.5.0-Beta release testing

[peteGSX]

Testing configuration

• CommandStation-EX version: iDCC-EX V-4.2.4 rc2
• Turntable-EX version: v0.5.0-Beta
• Microcontroller: STM32F411RE
• Stepper driver: A4988
• Stepper motor: NEMA17
• Homing sensor: Micro switch (limit also) - traverser mode
• Dual relay board: N/A

If you have edited config.h in Turntable-EX or myHalcpp or myAutomation.h in CommandStation-EX, please upload those to this issue also.

Test 1 - Startup Sequence

Pass

Any observations or comments:

Test 2 - Turntable-EX is Available

Pass

Any observations or comments:

Test 3 - Basic Movement with Automatic Phase Switching

Test 3, Part 1 - Clockwise

Pass

Any observations or comments:

Test 3, Part 2 - Counter Clockwise

Pass

Any observations or comments:

Test 4 - Homing

Pass

Any observations or comments:

Test 5 - Calibration

Pass

Any observations or comments:

Test 6 - LED Output Testing

Pass

Any observations or comments:

Test 7 - Accessory Output Testing

Pass

Any observations or comments:

Test 8 - Manual Phase Switching

Not Tested

Any observations or comments:

Test 9 - Sensor Testing

Pass

Any observations or comments:

Test 10 - Traverser Mode

Pass

Any observations or comments:

General comments or feedback

Please share any general comments or feedback here: