search

DIYOSEPP / EspUnoWiFi

WiFi Serial and OTA bridge for UNO
23 stars 10 forks source link

Arduino Uno not being reset with Feather Huzzah ESP8266 #1

Open kabrio opened 5 years ago

kabrio commented 5 years ago

Hi,

I installed the software on ESP8266 Huzzah board and can connect to it. When uploading to Arduino Uno using Arduino IDE (selecting the network port) the upload fails as the Arduino is not being reset. 

Resetting the board
Failed to reset the board, upload failed

What am I doing wrong?

Kashyapkoshti commented 4 years ago

i am getting upload successfully but in flashing gets error in arduino uno.

DIYOSEPP commented 4 years ago

Hello,

We don’t sell Arduino WiFi or modules to make it WiFi enabled. Unfortunately I do not have experience with this and am unable to offer assistance.

Daniel | OSEPP Senior Designer & Sales OSEPP Electronics inc | http://osepp.com/ mobile: (786)-253-4040 Email: danny@osepp.com

On Dec 12, 2019, at 10:20 PM, Kashyapkoshti notifications@github.com wrote:

 i am getting upload successfully but in flashing gets error in arduino uno.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe.

kabrio commented 4 years ago

Thank you for the reply!

Wilhelm1Daniel commented 4 years ago

Be Sure to select the correct (reset) pin on your board. The Code is written to gpio 2.

I successfully tried the following connections:

ESP01S - UNO NODEMCU - UNO ESP01S - Pro Mini NodeMCU - Pro Mini D1 Mini - UNO and Pro Mini

next time I'll try it with a Nano